Dodge Dakota Blend Door Problems. You can take them off and move the doors by hand and, if they're stiff, try to get some lubricant in there and then move them by hand until they're loose again. If your under warranty take it in and the dealer will replace the motor.
I have a dodge durango 2001 and everything works on the from www.justanswer.com
If your not under warranty buy the the motor for $35 and drop the lower glove box door and you will see the lower motor behind the console. Something stinks and it ain't me.:funny: This worked for me, but i still have to work on the one that moves the door to the windshield defrost.
The Blend Door Is On The Pass Side Behind The Dash.
This worked for me, but i still have to work on the one that moves the door to the windshield defrost. It should turn freely to both sides; No.the door i was looking for is right next to the heater core.in the middle of the dash.
Idk If It Uses Engine Vacuum Or Electric Motor, As Either Could Cause The Blend Door To Not Function Properly.
If that happens, the blend door won't work, and it's likely your temperature will just be stuck on one setting with no ability to adjust the intensity up and down, or alternate between things like the lower vents or the defroster. The door can stop in any position and can sometimes partially stop the airflow from the ducts. It works together with the blend door itself.
2004 Dodge Dakota 4.7 Quad Cab With Air Hi Mine Seems To Just Blow In To The Dash When The.
If your not under warranty buy the the motor for $35 and drop the lower glove box door and you will see the lower motor behind the console. This is just something to give him heat for the winter. Its possible that you have a bad vent control switch.
The Average Cost For A Dodge Dakota Hvac Blend Door Actuator Replacement Is Between $277 And $339.
Check blend door actuator circuit resistance. I've been doing a lot of reading in old posts since i joined a couple of days ago. You need to remove the radio so you can see the cable, then move the temperature slider on the control head while watching the cable if it doesn't move then you'll either need a new cable or its came loose somewhere.
Labor Costs Are Estimated Between $238 And $300 While Parts Are Priced At $39.
If it’s hard to turn in full position, there could be an obstruction that could cause the new blend door actuator to fail. Discussion starter · #1 · feb 27, 2008. If the blend door isn’t moving freely, you have to remove the heater plenum and fix it before mounting the new actuator.
